Category: 드립-락 파이프 및 피팅
The O-ring and rotatable seal are a lifesaver when I need to adjust the angle after tightening everything down. Hooked it straight from my manifold to the drip line and not a single leak so far, even at full pressure.
Set this up from my manifold to a drip zone yesterday, and the stainless steel teeth grabbed the tubing with zero leaks even when I twisted the tee to adjust the line. The O-ring makes that threaded connection feel solid without needing a ton of wrench torque. Exactly what I needed for a clean trans
The rotatable seal is the standout—I can position the tee exactly where I need it after tightening, no fighting with the tubing. Snapped onto my riser in under a minute and not a single drip since.
